WARNINGS
1. The lighter contains flammable oil, so keep out of reach of children.
2. DO not put your fingers under flint when using to avoid any scratch.
3. Oil may overfiow when filling, so clean the lighter and your hands before using.
4. Keep the flame away from the lighter;blow out the flame after use rather than inserting the striking rod into the lighter.
5. Avoid long exposure to sunshine or a place where temperature is over 45 0c.
6. Do not keep the lighter burning longer than 10 seconds.
7. Fasten up the screw when you do not use the lighter any more, or oil will volatilize.
FILLING
1. Do not keep using the lighter if you find oil in sufficient,e. g. the flame is tiny and the lighter becomes difficult to ignite,or wick may get worn.
2. Remove out the striking rod and fill slowlythrough the open end. Do not overfill the lighter.
INSTRUCTIONS FOR USE
1. Hold the lighter by the side with your left hand and remove out the strikingrod.
2. Turn the lighter to a right position so that you can use striking rod with your right hand.
3. Strike forcibly the flint with the striking rod to ignite.
WICK ADJUSTMENT
When the wick is burned to black ,thewick will absorb the oil slowly and the lighter is not easy to lit on. Then the wick needs changing .please see the steps of changing wick as below.
1. Pull out the scraper with pliers.
2. Take out wick till suitable length and part them.
3. Put the scraper into the wick and then put the wick into the copper pipe.
4. If the wick is too long or not neat,use scissors to cut or prune.
5. The length of the wick out should be half of the length of scraper outside.
6. The length of the wick is limited.Do not cut it too often.We suggest cutting it every three month.
请各位英语高手帮我翻译下:因为用百度和谷歌翻译都有语法问题不正确,请做外贸等行家帮忙翻译下,小弟不甚感激!
真的不用软件没人懂么?下面两个都是用软件翻译的错的。请还有没有高手来露一手